"Plinky" (F21?): Modified "Phaser in space" patch. Essentially a clean, bluesey, phasor'd sound with a plinky-compressed snap. IMHO this sounds great for upper neck blues solos with the neck pickup. Curtis Pastor. INF / MIDI(100) Plinky.syx Midi Sysex data file for Patch #100 GSP-2101 2.01.01 Single Disc Factory Algorithm (21 or 22 I think???) This patch is essentially Phasor in space, but I started from scratch, just goofing around. Plink'sPissed is a variation using the Distorted Tube, which I think has ALOT of character over my cabs (sounds like hell over headphones tho). Turn down the phasor parameters (level, regen, depth) if you start to get motion sickness. I couldn't really set it well since my amp only has one functioning channel these days, and stereo phasors are illusive in mono. The phasor is really just there for added emphasis and character. I have a similar algorithm with the AutoWah mixed in just slightly for extra character, but it can be a bit much at times. Typical Notes: Be aware that the FxLoop may need to be reset for your particular rig. I generally set it to Bypass, but occassionally rely upon outboard gear, and thus have it set to NoSum. This may cause problems depending upon your setup. As always, some minor tweaking may be neccessary for Noise Gate, Master Volume, and Distortion settings, as guitar ouput voltages and impedances vary (and so do tubes for that matter). Finally, all cabinets are not created equal, and thus, you may need to add or drop some high end to get nearly the same sound I hear. I have Peavey Butcher cabs which are rather bright, but I'll let you be the judge. Also, for patches that require User algorithms, you may not be able to load the new algorithm if you are running low on algorithm space. I have found that I have a few algs sitting around in only a single patch that I don't even use! Obviously, I delete these to make room. Also, dual disc users should note that alg space goes right out the door when adding dual algs. I have stopped using dual algs, which is OK with me since all I wanted was the seemless switching anyhow. Perhaps Digitech will increase alg space/memory in the 2101's next-generation replacement. *********************************************************** *********************************************************** *********************************************************** ***** ***** ***** ! ! ! WARNING ! ! ! ***** ***** ***** ***** ***** ***** It is my understanding that when ***** ***** individual patches are saved via MIDI ***** ***** SYSEX program dump (NOT bulk dump), ***** ***** they must be reloaded into the program ***** ***** number they were saved as. For this ***** ***** reason, you should take care to protect ***** ***** your existing data. I have noted the ***** ***** program number that I saved the patch ***** ***** as so that you can do so. However, it ***** ***** is possible that a mistake has occured ***** ***** which could inadvertantly overwrite an ***** ***** existing patch. Therefore, you should ***** ***** first save ALL of your existing 2101 ***** ***** data via a BULK DUMP to your computer ***** ***** so that you may easily restore your ***** ***** previous settings. ***** ***** ***** ***** ***** *********************************************************** *********************************************************** *********************************************************** #============================================================ #============================================================ # # +--------------------+ # |Plinky | # |St Pha~Dly~Revrb | # | | # | | # +--------------------+ # # Date Created: 2/26/97 # #============================================================ #============================================================ GSP-2101 # Device ID 2.00.00 # Software Version Plinky # Program Name F12 # Algorithm Comp ( ### Compressor On, # Compr 7:1, # Ratio -45dB, # Thresh 0 dB # Level ) Dist ( ### Distortion On, # Distrt Clean Tube, # Type 4.6 # Gain1 ) EQ ( ### Analog Graphic EQ +4dB, # 80 Hz +2dB, # 160 Hz 0dB, # 320 Hz -6dB, # 640 Hz -4dB, # 1.28 Hz +6dB, # 2.56 Hz +12dB # 5.12 Hz ) MVol (0) ### Master Volume FxL (Summed) ### External Effects Loop NGt ( ### Stereo Noise Gate On, # SNGt -66dB, # Thresh 8dB, # Hyster 153ms, # HldTim 0ms, # Attack 550ms, # Releas 25dB, # Attn 5.0ms # Delay ) SPha ( ### Stereo Phaser On, # Phaser 100, # Level 44 %, # Regen 0.47Hz, # Speed 69, # Depth Sine # WvForm ) 4x2A ( ### 4x2 Mixer 100, # Input 1 Lev -50, # Input 1 Pan 100, # Input 2 Lev 50, # Input 2 Pan 50, # Input 3 Lev 0, # Input 3 Pan 50, # Input 4 Lev 0, # Input 4 Pan 100, # OutL 100 # OutR ) SDly2 ( ### Stereo Delay 2.0 Sec On, # Dly2.0 0.450, # Delay 50 %, # Fdback 20, # Level Off # RptHld ) 4x2B ( ### 4x2 Mixer 100, # Input 1 Lev -50, # Input 1 Pan 100, # Input 2 Lev 50, # Input 2 Pan 100, # Input 3 Lev -50, # Input 3 Pan 100, # Input 4 Lev 50, # Input 4 Pan 100, # OutL 100 # OutR ) 2x1 ( ### 2x1 Mixer 50, # Lev1 50, # Lev2 100 # OutLev ) MVrb ( ### Multi-FX Reverb On, # Reverb 15ms, # PreDly 100ms, # Spread 5, # Diffsn 20000, # HFDecy 16000, # Roloff 10, # Size 7.00 S, # RT60 15 # Level ) 4x2C ( ### 4x2 Mixer 100, # Input 1 Lev -50, # Input 1 Pan 100, # Input 2 Lev 50, # Input 2 Pan 100, # Input 3 Lev -50, # Input 3 Pan 100, # Input 4 Lev 50, # Input 4 Pan 100, # OutL 100 # OutR ) MMix (100:W) ### Master Mix #============================================================ #============================================================ # END OF PROGRAM #============================================================ # Produced by "SAP v1.00" by Tom Owens (exigy@one.net) #============================================================